Bonding Agent
PRODUCT DATA SHEET
  

TILELOC | Bonding Agent

 
COMPOSITION:

Tile-Loc is a Copolymer Latex Bonding & Waterproofing aid.
PROPERTIES & USES:

Tile-Loc has been designed specifically for use in the Building Industry as a water resistant additive and to assist bonding of Tiles to smooth surfaces such as off shutter concrete, existing ceramic tiles & vinyls.
FEATURES & ADVANTAGES:
• Improves non-structural bond of tiles to smooth concrete.
• Improves non-structural bond of floor screeds to smooth concrete.
• Waterproofing additive.
• No more hacking & chipping of smooth surfaces.
• Easy to use.
SURFACE PREPARATION:
Surfaces should be free of loose particles, crumbling or flaking material, grease, dust or polish. Wire brush the area if necessary and dampen prior to priming.
APPLICATION:
TILING WITH CEMENT BASED POWDER ADHESIVES

Apply a slurry coat - 2 parts cement and 1 part Tile-Loc (by volume)- to the prepared area and while the slurry coat is still wet continue to tile in the usual manner. Tile-Loc can be added to the adhesive mix to obtain a stronger bond. (10% of water content)

TILING WITH READY-MIX ADHESIVE

Apply Tile-Loc with a brush to the prepared surface, allows the Tile-Loc to become tacky then continue tiling in the usual manner.
FLOOR SCREEDS:
PREPARATION

In addition to the normal preparation it may be necessary to use a mechanical scabbler to remove all unsound material, or to etch the concrete with diluted Hydrochloric Acid followed by a thorough washing with clean water to remove all traces of acid. Thoroughly dampen floor prior to application of slurry coat.

APPLICATION

Apply a slurry coat - 2 parts cement and 1 part Tile-Loc (by volume) to the prepared area using a stiff broom and continue screeding in the normal manner (while the slurry coat is still wet).

FOR GENERAL PURPOSE TOPPING AND PATCHING THE FOLLOWING COMPOSITION IS SUGGESTED.

Sand - 100kgs
Cement - 33kgs
Tile-loc - 6lts
Water - As required to adjust consistency.

COVERAGE

Topping / Patching (using above mix) -0.07m³
Slurry Coat -3-4m² per Litre

TECHNICAL DATA TILE-LOC

APPEARANCE: MILKY WHITE
SPECIFIC GRAVITY: 1.0
pH: 1.0
FLASH POINT: NIL
PHYSICAL FORM: LIQUID
PACKAGING: 210lt 25lt 5lt 1lt

 
MANUFACTURED BY A. SHAK (PTY) Ltd. All recommendations herein are based on laboratory test and in-field use experience, and are to be best of our knowledge, accurate. Since conditions of actual use are beyond our control, all recommendations are made without warranty, express or implied.
PO Box 10449, Edenglen, Sebenza, 1613 - 473 Sam Green Road, Greenhills, Tunney 1429, Website: www.ashak.co.za
Tel: 0861-127425 (ASHAK) or +27(11) 822-2320, Fax: +27 (11) 822-2354 or 0866-766-232, email: sales@ashak.co.za